fuel steam atmospheric pressure water tube boiler

fuel steam atmospheric pressure water tube boiler

ZOZEN has built six fully automatic lines for the production of convection pipe, coil pipe, threaded pipe, membrane wall, serpentine tube and header. The parts so produced have consistent dimensions that enable easy assembly and ten years’ extension of a boiler’s life.


1. Convection pipe production line: high precision of ±0.5MM.
2. Coil pipe production line: three pieces of pipes can be coiled at the same time. 114mm diameter pipes are coiled into 4.5 meters coil.
3. Threaded smoke pipe production line: tread depth is accurately measured by infrared radiation to ensure tread depth is proper.
4. Membrane wall production line: MPM automatic welding machine with 12 heads, 1600MM panel bending machine.
5. Serpentine tube production line: 150 meters pipe can be made into economizer or super heater in one time without manual seam.
6. Header production line: by medium frequency electric heating, mechanical flow forming closing and NC drilling.

Our Lastest Boiler Type

Seven Hold Points

Seven hold points are set and each one is supervised by a responsible inspector. Any work that fails to pass the inspection cannot proceed until the inspector is able to verify its quality.

1,Incoming materials are inspected again upon entry into the plant.

2,Material markings will be transferred to all cut pieces to ensure identification and traceability.

3,Test pieces are used to ensure a higher success rate in welding.

Unique structural design

National Precision Bearing offers stainless steel for applications that require corrosion resistance.We have world class manufacuring facilities using latest technology, machines and equipments.

Contact Us

Chapter 24: Fuel Gas, Residential Code 2012

The text of this chapter is extracted from the 2012 edition of the International Fuel Gas Code and has been modified where necessary to conform to the scope of application of the International Residential Code for One- and Two-Family Dwellings.The section numbers appearing in parentheses after each section number are the section numbers of the corresponding text in the International Fuel Gas Code.

Contact us

New Page 1 [earlyamericanautomobile

Newburyport. Curtis Steamer 1867. 1867 Curtis Steamer. Francis Curtis was the superintendent of the Gas Works in Newburyport and in 1866, he invented a steam engine which was attached to a piece of fire fighting equipment.

Contact us

MHI Superheated Steam Generators One Atmosphe

Steam Technology for Significant Energy and Water Savings. One Atmosphere Boiler (OAB) ;

Contact us

Water-tube boiler - Wikiped

A high pressure watertube boiler (also spelled water-tube and water tube) is a type of boiler in which water circulates in tubes heated externally by the fire. Fuel is burned inside the furnace, creating hot gas which heats water in the steam-generating tubes.In smaller boilers, additional generating tubes are separate in the furnace, while larger utility boilers rely on the water-filled tubes

Contact us

New Page 1 [earlyamericanautomobile

Newburyport. Curtis Steamer 1867. 1867 Curtis Steamer. Francis Curtis was the superintendent of the Gas Works in Newburyport and in 1866, he invented a steam engine which was attached to a piece of fire fighting equipment.

Contact us

Chapter 2: Definitions, 2012 Virginia Residential Cod

BACKFLOW, WATER DISTRIBUTION.The flow of water or other liquids into the potable water-supply piping from any sources other than its intended source. Backsiphonage is one type of backflow.. BACKPRESSURE.Pressure created by any means in the water distribution system, which by being in excess of the pressure in the water supply mains causes a potential backflow condition.

Contact us

ASME.PTC4.1 .Boiler efficiency test | Boiler | Ste

1. ENERGY PERFORMANCE ASSESSMENT OF BOILERS 1.1 Introduction Performance of the boiler, like efficiency and evaporation ratio reduces with time, due to poor combustion, heat transfer fouling and poor operation and maintenance.

Contact us

Steam Glossary | The Railway Technical Website | P

Here is a collection of over 300 descriptions of the parts of the steam locomotive compiled to assist locomotive enthusiasts to further their knowledge of the most remarkable mechanical machine ever created by man.

Contact us

Newcomen atmospheric engine - Wikiped

The atmospheric engine was invented by Thomas Newcomen in 1712, and is often referred to simply as a Newcomen engine. The engine was operated by condensing steam drawn into the cylinder, thereby creating a partial vacuum which allowed the atmospheric pressure to push the piston into the cylinder. It was the first practical device to harness

Contact us

Home | Rite Engineering ; Manufacturing Cor

High Pressure Steam Boilers (150 PSI) From food processing to textiles, hospitals to industrial process manufacturing - these heavy duty watertube steamers are available in 16 different models.

Contact us

New Page 1 [earlyamericanautomobile

Newburyport. Curtis Steamer 1867. 1867 Curtis Steamer. Francis Curtis was the superintendent of the Gas Works in Newburyport and in 1866, he invented a steam engine which was attached to a piece of fire fighting equipment.

Contact us