fire brick lining of bm water tube boiler was found collapsed
ZOZEN has built six fully automatic lines for the production of convection pipe, coil pipe, threaded pipe, membrane wall, serpentine tube and header. The parts so produced have consistent dimensions that enable easy assembly and ten years’ extension of a boiler’s life.
1. Convection pipe production line: high precision of ±0.5MM.
2. Coil pipe production line: three pieces of pipes can be coiled at the same time. 114mm diameter pipes are coiled into 4.5 meters coil.
3. Threaded smoke pipe production line: tread depth is accurately measured by infrared radiation to ensure tread depth is proper.
4. Membrane wall production line: MPM automatic welding machine with 12 heads, 1600MM panel bending machine.
5. Serpentine tube production line: 150 meters pipe can be made into economizer or super heater in one time without manual seam.
6. Header production line: by medium frequency electric heating, mechanical flow forming closing and NC drilling.
Our Lastest Boiler Type
- reassemble a boiler
- m land rover parts waste oil burner of boiler curing furnace original
- 5 ton four pass boiler tunisia use for winery high quality in zimbabwe
- life natural gas hot water fire tube boiler for sale in bulgaria
- electricity natural gas hot water atmospheric pressure water tube boiler dealer
- gas fired steam boiler with ce premium sealed
- công ty tnhh mtv nồi hơi đất việt
- blind coal steam boiler widely used
- boiler manufacturers in pakistan
- hot water boiler suppliers in malaysia best price
- manufacturers of boiler for water purification system
- heating fuel hot water vacuum fire tube boiler manufacturers
Seven Hold Points
Seven hold points are set and each one is supervised by a responsible inspector. Any work that fails to pass the inspection cannot proceed until the inspector is able to verify its quality.
1,Incoming materials are inspected again upon entry into the plant.
2,Material markings will be transferred to all cut pieces to ensure identification and traceability.
3,Test pieces are used to ensure a higher success rate in welding.